Einloggen um die Werbung zu entfernen!

New MiruMod Rev.020

Mehr Reichweite für die AR.Drone mit dem MiruMod. Auch bekannt unter: MacGyver, RC Kit, RC Umbau
Antworten
Trans-Island
Abstandhalter
Beiträge: 27
Registriert: 30. Mai 2013 02:31
Copter: AR.Drone 2
Hat sich bedankt: 0
Danksagung erhalten: 0

New MiruMod Rev.020

Beitrag von Trans-Island » 22. Jul 2013 03:48

Hello everyone,

Miru announce the release for the long awaited rev .020
Please read the new features available.
http://www.rcgroups.com/forums/showpost ... count=5150

Thank you.

Patrick

Blauer Jens
Abstandhalter
Beiträge: 23
Registriert: 7. Jul 2013 07:34
Copter: AR.Drone 2
Hat sich bedankt: 0
Danksagung erhalten: 0

Re: New MiruMod Rev.020

Beitrag von Blauer Jens » 22. Jul 2013 21:44

Hello Patrick,

Thank you for your information. The new version works fine, but I would like to mention, that some modification is necessary to make it run.

1. The default setting of the input ports has been changed to ascending order. This is not in line with the normal wiring layout. To solve this, the definition in line 2892 (#define RX_CON 1) has to be changed to #define RX_CON 0

2. Due to the new setting of GSWO (see Readme), it is necessary to have the GEAR Pin connected to the Receiver, otherwise the Drone won't start. Some User don't have wired this Pin, so they have to switch GSWO back to "Disabled" or connect the Pin to AUX1 Pin.

I think Miru did a good job, with the new release.

Best regards, Jens

Antworten